Olympus UK E-System User Group

Olympus UK E-System User Group (https://e-group.uk.net/forum/index.php)
-   Olympus E-3 (https://e-group.uk.net/forum/forumdisplay.php?f=14)
-   -   Camera stopped working (https://e-group.uk.net/forum/showthread.php?t=6610)

sapper 20th September 2009 07:35 AM

Camera stopped working
 
Out taking night shots in London 'tother night, everything OK (once I remembered to turn IS off!) then the camera just stoppd taking pics. It made all the right noises but no pic. I turned it off and on a few times but it would not take any more pics.
The next morning it worked OK, I used it all day and it has not been a problem at all.
I have a feeling that it will have to go off to Oly but has anyone had this problem?
I was annoyed as I had the E1 as back up but didn't take it out with me.
I was shooting RAW, 5 sec delay on manual.

johnwb 20th September 2009 09:01 AM

Re: Camera stopped working
 
Hi Dave,

Happened to me with a 520 on Saturday. Camera was fully functional and then could not do a playback of images, nor raise the information screen. I shut the camera off and felt the 'issie' shudder. Switched back on after 5 secs and saw the dust light activation, and thought the batterries are OK, but still no information screen, or playback. Repeated the operation but no progress. Minor panic!

I then checked the camera over fully to see what was functioning and what was not, and to check the battery level: but no screen, so no check, no other way to check on a 520. Switched off, and again the 'issie' shudder. Again I thought 'batteries OK'.

However I replaced the batteries with a recharged set and 'bingo' all was well. I had no prior indication of battery level dropping at all during the initial run with the camera. It was fully functional and then suddenly problems. My initial checks on battery condition were fine.

I would suggest you check for a bad contact, and clean the contacts. If it happens again - check the camera immediatly with a fully recharged battery to see if you can replicate the problem. The fact that the camera was well the following time you used it suggests to me that the the batteries may have had time to 'recover' enough to continue, but you do not say how long this original set lasted until a recharge was needed.

I do understand you were shooting 'RAW' and at 5 secs, all power hungry operations causing a quicker battery drain.

Good luck!
Regards JohnWB

sapper 20th September 2009 09:29 AM

Re: Camera stopped working
 
[QUOTE=johnwb;52021]Hi Dave,

Happened to me with a 520 on Saturday. Camera was fully functional and then could not do a playback of images, nor raise the information screen. I shut the camera off and felt the 'issie' shudder. Switched back on after 5 secs and saw the dust light activation, and thought the batterries are OK, but still no information screen, or playback. Repeated the operation but no progress. Minor panic!

I then checked the camera over fully to see what was functioning and what was not, and to check the battery level: but no screen, so no check, no other way to check on a 520. Switched off, and again the 'issie' shudder. Again I thought 'batteries OK'.

However I replaced the batteries with a recharged set and 'bingo' all was well. I had no prior indication of battery level dropping at all during the initial run with the camera. It was fully functional and then suddenly problems. My initial checks on battery condition were fine.

I would suggest you check for a bad contact, and clean the contacts. If it happens again - check the camera immediatly with a fully recharged battery to see if you can replicate the problem. The fact that the camera was well the following time you used it suggests to me that the the batteries may have had time to 'recover' enough to continue, but you do not say how long this original set lasted until a recharge was needed.

I do understand you were shooting 'RAW' and at 5 secs, all power hungry operations causing a quicker battery drain.

Thanks for this John.

What happened to you seems quite different than what happened to me.
The camera appeared to be fully functional. All screens were OK. Menu buttons worked Etc. Battery OK. (I used the same battery all of the next day, 180 shots)
I could frame the shot on screen, focus, then take the shot. Camera made shutter noise but no delayed action and it just returned to the shooting screen. On checking playback, no pic had been recorded.

Someone on another forum did say that the sensor could have overheated so didn't record image. Must check the manual.
Thanks again.

EH1 20th September 2009 12:06 PM

Re: Camera stopped working
 
Dave I have experienced this fault with one of my e-3`s many months ago! After alot of playing around I thought it was the dreaded battery grip, but I also tryed the camera without the grip & still had the same problem! In the end as a last resort I RESET the camera back to factory default settings & touch wood never had this problem again! So it is well worth a try ;)

sapper 20th September 2009 01:47 PM

Re: Camera stopped working
 
Thanks Edward, I will try that.

Kiwi Paul 21st September 2009 02:23 PM

Re: Camera stopped working
 
Or even try just removing the battery, waiting a few seconds and putting it back in.

Paul


All times are GMT. The time now is 11:20 AM.


The Write Technology Ltd, 2007-2019, All rights reservedAd Management plugin by RedTyger